There are
many post is available on this topic, but it not understand by students because
of multi layers design in proteus, and how to handle this layer design, as a
student I can post this simple design step by step
I can take
an example in my old post Simple Adjustable DC power
supply(simple RPS)
and explained step by step
1. First take design circuit on proteus
Isis. wrong connection will lead to wrong tracks in PCB, so be careful or
simulate the circuit as well as possible
2. Now click on ARES in top of the
window
3. Now u can enter in PCB editing
windows in this u can see some important tools show in fig like
4. First you will select board size by
using 2D graphics mode box
And select the board edge in layer selector
Now drag on window according to size of board
5. Now you can use any of this two
methods
1. Auto placer
2. Manual placing
In auto placer option it
will place components automatically in between board edge
In manual placing of
components will select components and place it
6. Now it’s time route
In routing also two options is available
1. Auto rout
2. Manual routing
I prepare auto and take same manual adjustments
Adjust components and tracks according to u required
Important:
In proteus can support only two or more layer PCB, in above
fig blue tracks are bottom tracks and red tracks are top tracks, so in places
of top tracks u can use jumpers as shown in fig below.
7. Check errors in design
8. 3d components visualizer in proteus
to check practical board
9.
Take output print of PCB layers
Thank you any question comment
below
No comments:
Post a Comment